Resources

Article · 2 November 2026 · 2 min read

What an energy audit report should tell you

A useful audit ranks fixes by rupee value and says how sure it is. A checklist for reading one, whoever writes it.

Illustration: audit-report

An energy audit only pays for itself if someone acts on it. The best reports are short at the top and specific about money.

A checklist for any audit report

  1. A ranked list of fixes, each with an estimated rupee value per year and the cost to do it.
  2. Tariff category check: are you on the right category for your load?
  3. Contract demand vs real demand, month by month.
  4. Power factor and kVAh effects, with the likely cause.
  5. Peak-hour use, and what moving it is worth.
  6. The working: how each estimate was made, so your own engineer can check it.
Start from the bills. Twelve months of DISCOM bills already show contract demand, real peaks, PF penalties and ToD surcharges. A bill review is a quick, low-cost first step before a full site audit.

Red flags in a report

  • Savings stated as a single percentage, with no rupee value or method
  • Recommendations that are generic (“replace with efficient motors”) with no site detail
  • No ranking, so the cheapest high-value fix is buried on page 60
Most savings found in an audit come back within a year unless someone keeps watching.

Ardra's engineer-led audit starts from your bills and sends a written report with fixes ranked by rupee value, then Ardra EMS can watch the same items every day.

Keep reading

Want this read on your own bill?

Request a demo
Request a demo